Beretta Ciao At 25 Csi Condensing Boiler Complete With LPG Fume Exhaust Kit - New Erp

BERETTA CIAO AT 25 CSI CONDENSING BOILER COMPLETE WITH LPG FUME EXHAUST KIT - NEW ErP

• Product code: 20113788

Characteristics:

• Energy efficiency in heating: B
• Energy efficiency Sanitary: A
• Sanitary load profile: XL
• Nominal heat input: 25 kW
• Electric Power: 129W
• Supply voltage/frequency: 230/50 Volt/Hz
• Electrical protection degree: X5D ip
• Dimensions HxWxD: 780 x 400 x 338 ; 40 Kg
• Gas version available: METHANE

Warm-up exercise:

• Maximum pressure and temperatures: 3/90 bar/°C
• Heating temperature selection range: 40/80 °C
• Pump: pump head available for the system: 266 m/bar
• Expansion tank capacity: 8 l

Healthcare exercise:

• Maximum pressure: 6 bars
• Minimum pressure: 0.15 bar
• Quantity of hot water with ∆t=25°C: 14.3 l/min
• Minimum domestic water flow rate: 2 l/min
• DHW temperature selection range: 37 - 60 °C

Beretta HELLO AT

Hi AT, ideal for replacement in systems with radiators. Ciao AT is the innovative condensing boiler specifically designed by Beretta for traditional high temperature systems (radiators and radiators). The boiler is equipped with a heat recovery unit on the fumes and combustion in a sealed chamber; this allows to obtain very high performance in terms of efficiency and therefore a significant energy saving.

High performance and low consumption In the Ciao AT boiler, the water in the primary circuit passes through an additional exchanger, which allows you to recover energy that would otherwise be wasted. This process makes it possible to recover latent heat and therefore to further increase the performance of the boiler. The energy saving offered by a boiler is greater the higher its efficiency: Ciao AT therefore allows you to reduce gas consumption compared to a boiler without an additional exchanger.

Management: The electronic panel is the interface for managing the boiler. Simple and intuitive, it allows you to adjust the boiler parameters and activate the numerous functions. The liquid crystal display provides information on the status of the device and the diagnostic codes. By turning the knobs, the heating water and domestic hot water temperature can be set easily and intuitively. The panel integrates the Sistema Clima Amico function.

The Ciao AT technology makes use of the condensing exchanger which recovers the latent heat of the fumes, the same principle used by condensing boilers. The exchanger, located at the top left, is connected directly to the fan which pushes the fumes inside it, before they are definitively expelled. The difference in the temperature of the fumes between the ~140°C inlet and the ~65°C outlet of the condensing exchanger is indicative of the amount of heat recovered from them.

The return from the system first passes through the condensing exchanger which recovers the heat from the fumes, and then passes through the primary exchanger, where it receives the remaining heat in order to reach the required flow temperature. The water then recovers part of the heat from the fumes, which would otherwise be expelled into the atmosphere, thus giving rise to less waste and consequently greater savings for the user.

Outdoor installation: Ciao AT is designed to also be installed outdoors in partially protected places thanks to the dedicated accessories (bottom cover kit and top cover kit) and board anti-freeze protection down to 0 °C. In colder temperatures it is possible to extend the protection down to -10 °C using the special antifreeze heater kit with which the lower cover is required.

Up to 17 meters of Ø 60 ducting with the Ciao AT boiler: With Ciao AT it is possible to comfortably duct even the most "difficult" flues thanks to the approval for Ø 60mm flue systems which is added to the traditional Ø 80 mm ducting flue system. The main 60mm flue ducts are available in the Beretta price list catalogue, while the boiler manuals provide indications of the maximum length, which differ according to the boiler power.

TECHNICAL FEATURES:

• Specific for systems with radiators and radiators (at high temperature)
• Condensing post exchanger in aluminum alloy
• Possibility of outdoor installation with antifreeze heater kit (optional)
• IPX5D electrical protection degree
• Environmental Self-Regulation System (SARA)
• Low consumption circulator 6 m (EEI≤0.20)
• Hydraulic connections cover (optional)
• Condensate collection neutralizer drawer kit (optional)
• Template, hydraulic fittings, gas and sanitary taps (optional)
• For gas conversion, contact authorized Beretta Technical Assistance Centres

Product Guarantee
All products for sale on our site are new and packed. The warranty on this item is 24 months from the date of purchase.

• peso: 30.0 kg
• classe energetica produzione acs: A
• classe energetica riscaldamento: B
• gas: LPG
• marca: BERETTA
• metri quadri : 150
• modello: CALD_1908G
• potenza in kw: 25
• potenza nominale: 25
• superficie riscaldabile mq: 150